Showing 1–20 of 119 results

  • Fully sublimated polyester fabric shower curtain measures 72″ x 72″

    Featuring custom, original art from a painting by Gwen AP.

    Estimated ship date Dec 17

    Add to cart

    tDB Shower Curtain – GwenAP art

    $55.00

    Fully sublimated polyester fabric shower curtain measures 72″ x 72″

    Featuring custom, original art from a painting by Gwen AP.

    Estimated ship date Dec 17

    Add to cart
  • Custom knit-in logo jaquard dress socks. 

    Choice of two colors – maroon or blue

    Anticipated ship date 12/19 – cannot guarantee delivery by Xmas Eve.

    Select options

    Disco Biscuits knit dress socks – color options

    $15.00

    Custom knit-in logo jaquard dress socks. 

    Choice of two colors – maroon or blue

    Anticipated ship date 12/19 – cannot guarantee delivery by Xmas Eve.

    Select options
  • This is a preorder expected to ship the week of 12/3

    This high-quality, lightweight zip-up water-resistant windbreaker features embroidered logo front left chest.

    Your choice of two colors, black/gray or black/camo.

    Jacket specs:

    • 82 Gm 100% polyester fabric with interior water resistant coating
    • matte finish eyelets and zippers
    • three panel hood with fine mesh liner
    • scuba neck with self neck tape
    • welt pockets with mesh pocket bags
    • tightening toggle at waistband
    • elastic cuffs
    • locker loop in center back
    Select options

    Lightweight Zip Windbreaker – color options

    $65.00

    This is a preorder expected to ship the week of 12/3

    This high-quality, lightweight zip-up water-resistant windbreaker features embroidered logo front left chest.

    Your choice of two colors, black/gray or black/camo.

    Jacket specs:

    • 82 Gm 100% polyester fabric with interior water resistant coating
    • matte finish eyelets and zippers
    • three panel hood with fine mesh liner
    • scuba neck with self neck tape
    • welt pockets with mesh pocket bags
    • tightening toggle at waistband
    • elastic cuffs
    • locker loop in center back
    Select options
  • Add to cart

    NEW DB Woven Throw Blanket

    $65.00
    Add to cart
  • Silicone cell phone wallet hold cards and cash, and bends to serve as a phone stand.

    Black with white imprint.

    Add to cart

    Cell Phone Credit Card Sleeve with stand

    $10.00

    Silicone cell phone wallet hold cards and cash, and bends to serve as a phone stand.

    Black with white imprint.

    Add to cart
  • Select options

    Ladies Hoodie Dress

    $65.00
    Select options
  • Embroidered gold Disco Biscuits crest on the front left chest. Choice of black or purple robe.

    Made of 100% microfiber polyester fleece fabric, this is THE most luxurious fleece robe available.

    • One Size
    • 48” long
    • 2 patch pockets
    • 100% microfiber polyester
    Select options

    tDB Embroidered Robe – color options

    $85.00

    Embroidered gold Disco Biscuits crest on the front left chest. Choice of black or purple robe.

    Made of 100% microfiber polyester fleece fabric, this is THE most luxurious fleece robe available.

    • One Size
    • 48” long
    • 2 patch pockets
    • 100% microfiber polyester
    Select options
  • High-quality, sublimated full-color all-over print ladies leggings.

    Full length leggings with comfortable waistband.

    Select options

    tDB New Ladies Leggings

    $65.00

    High-quality, sublimated full-color all-over print ladies leggings.

    Full length leggings with comfortable waistband.

    Select options
  • Select options

    Unisex Bomber Jacket

    $85.00
    Select options
  • High-quality nylon water-resistant windbreaker anorak jacket features an embroidered logo on the right shoulder, and the screenprinted band name on the pouch pocket.

    Choice of two colors, navy or black. Please note backordered sizes on Black: small, large and XL.

    The nylon exterior fabric of the jacket is coated with a 100% waterproof coating; seams are highly water resistant but not waterproof.

    • 100% nylon 330D with Interior PU waterproof coating
    • matte metal zipper pull with rubber zipper pull tab
    • 3 panel hood with fine mesh hood liner
    • matte nickel metal eyelets and round poly drawstring
    • scuba neck
    • hidden snaps inside front pocket flap
    • side slit pockets
    • tightening toggle at waistband
    • elastic cuffs
    Select options

    Disco Biscuits Water Resistant Pouch Windbreaker

    $85.00

    High-quality nylon water-resistant windbreaker anorak jacket features an embroidered logo on the right shoulder, and the screenprinted band name on the pouch pocket.

    Choice of two colors, navy or black. Please note backordered sizes on Black: small, large and XL.

    The nylon exterior fabric of the jacket is coated with a 100% waterproof coating; seams are highly water resistant but not waterproof.

    • 100% nylon 330D with Interior PU waterproof coating
    • matte metal zipper pull with rubber zipper pull tab
    • 3 panel hood with fine mesh hood liner
    • matte nickel metal eyelets and round poly drawstring
    • scuba neck
    • hidden snaps inside front pocket flap
    • side slit pockets
    • tightening toggle at waistband
    • elastic cuffs
    Select options
  • This 6″ Snowboard Stomp pad protect assists riders when getting off of chair lifts. Mounted between the bindings, stomp pads are used to secure the rear foot when getting off of a chair lift at the top of the mountain. All pads come with high performance adhesive for secure mounting to the board by the recipient. Logo is protected under the clear material of the pad, which provides traction for keeping the rear foot in position.

    INSTALLATION INSTRUCTIONS:

    You want to install your stomp pad as close to your back binding as you can – this will make it feel as close to your normal stance as you can make it. And it will also mean that you can lean your boot against the binding for extra stability.

    Make sure that you position the stomp pad on the inside of the back binding.

    Here’s how to find the best spot for your stomp pad.

    1. Place your snowboard on the ground and put your boots on
    2. Place your back foot on the snowboard on the inside of the back binding, close to the back binding so that you are still standing upright and so that the side of your boot is touching the side of the binding
    3. Mark the points on the board where the inside and outside of your boots touch the board
    4. When you place your stomp pad it should be inside these tape marks (or at least not outside the tape mark that’s next to the binding)

    Installing the stomp pad

    Now you have the position of your stomp pad it’s time to install it/them

    1. Thoroughly clean and dry the area of your board where you will be placing the stomp pad/s. If you try to attach them to a dusty, unclean or wet surface they may lose their stick quickly
    2. To ensure the best possible stick make sure that you are in a warm room or heat up the boards surface with a hair dryer
    3. Remove the backing to expose the adhesive and place on your stomp pad.
    4. Then remove the other side of adhesive and place the stomp pad in the position you marked earlier. Press down as hard as possible and hold the pad in place for a while.
    5. Let the adhesive dry for 24 hours.
    Add to cart

    tDB Snowboard Stomp pad

    $20.00

    This 6″ Snowboard Stomp pad protect assists riders when getting off of chair lifts. Mounted between the bindings, stomp pads are used to secure the rear foot when getting off of a chair lift at the top of the mountain. All pads come with high performance adhesive for secure mounting to the board by the recipient. Logo is protected under the clear material of the pad, which provides traction for keeping the rear foot in position.

    INSTALLATION INSTRUCTIONS:

    You want to install your stomp pad as close to your back binding as you can – this will make it feel as close to your normal stance as you can make it. And it will also mean that you can lean your boot against the binding for extra stability.

    Make sure that you position the stomp pad on the inside of the back binding.

    Here’s how to find the best spot for your stomp pad.

    1. Place your snowboard on the ground and put your boots on
    2. Place your back foot on the snowboard on the inside of the back binding, close to the back binding so that you are still standing upright and so that the side of your boot is touching the side of the binding
    3. Mark the points on the board where the inside and outside of your boots touch the board
    4. When you place your stomp pad it should be inside these tape marks (or at least not outside the tape mark that’s next to the binding)

    Installing the stomp pad

    Now you have the position of your stomp pad it’s time to install it/them

    1. Thoroughly clean and dry the area of your board where you will be placing the stomp pad/s. If you try to attach them to a dusty, unclean or wet surface they may lose their stick quickly
    2. To ensure the best possible stick make sure that you are in a warm room or heat up the boards surface with a hair dryer
    3. Remove the backing to expose the adhesive and place on your stomp pad.
    4. Then remove the other side of adhesive and place the stomp pad in the position you marked earlier. Press down as hard as possible and hold the pad in place for a while.
    5. Let the adhesive dry for 24 hours.
    Add to cart
  • 1/4″ thick acrylic magnet with full color design

    Design by Christian Jaxheimer

    Add to cart

    Disco Biscuits Acrylic Magnet

    $8.00

    1/4″ thick acrylic magnet with full color design

    Design by Christian Jaxheimer

    Add to cart
  • Add to cart

    Robot Koozie

    $5.00
    Add to cart
  • Add to cart

    Speaker Koozie

    $5.00
    Add to cart
  • The Disco Biscuits continue the systematic release of their most beloved albums on vinyl with the 15th Anniversary Edition of TranceFusionRadio Broadcast 01 & 02!

    Recorded during the band’s 2002 New Year’s Run, the TranceFusionRadio series dutifully served many listeners as an introduction to The Disco Biscuits’ unique blend of electronica-infused jam known to their dedicated fans as TranceFusion. Now, 15 years later, the first two installments of TranceFusionRadio are back and better than ever for their “crystal anniversary.”

    Remastered audio by Jon Altschiller has been pressed onto three, 140g virgin vinyl discs, and contained within brilliantly redesigned packaging by Ben Langsfeld – both of whom worked on the first edition release. Each box set also includes 2 CDs, an mp3 download card and a DVD of 12/29/02 set II!

    TranceFusionRadio Broadcast 01 & 02 // Remastered 15th Anniversary Edition

    Add to cart
    Sale

    TranceFusionRadio Broadcast 01 & 02 // Remastered 15th Anniversary Edition

    $100.00 $65.00

    The Disco Biscuits continue the systematic release of their most beloved albums on vinyl with the 15th Anniversary Edition of TranceFusionRadio Broadcast 01 & 02!

    Recorded during the band’s 2002 New Year’s Run, the TranceFusionRadio series dutifully served many listeners as an introduction to The Disco Biscuits’ unique blend of electronica-infused jam known to their dedicated fans as TranceFusion. Now, 15 years later, the first two installments of TranceFusionRadio are back and better than ever for their “crystal anniversary.”

    Remastered audio by Jon Altschiller has been pressed onto three, 140g virgin vinyl discs, and contained within brilliantly redesigned packaging by Ben Langsfeld – both of whom worked on the first edition release. Each box set also includes 2 CDs, an mp3 download card and a DVD of 12/29/02 set II!

    TranceFusionRadio Broadcast 01 & 02 // Remastered 15th Anniversary Edition

    Add to cart
  • Add to cart
    Mystery Pin 3-Pack

    Mystery Pin 3-Pack

    $30.00
    Add to cart
  • Add to cart

    Mystery Poster 3-Pack

    $50.00
    Add to cart
  • Hydration backpack for use with water bladder

    Black and Gray, Embroidered with Logo

    Add to cart

    Hydration Pack

    $50.00

    Hydration backpack for use with water bladder

    Black and Gray, Embroidered with Logo

    Add to cart
  • Red, Blue, Green, Clear pint glass with “baked in” long lasting design, buy individual colors or save with a 4 pack!

    Select options

    Pint Glass – red

    $12.00

    Red, Blue, Green, Clear pint glass with “baked in” long lasting design, buy individual colors or save with a 4 pack!

    Select options
  • Add to cart

    Sublimation Turntable Slipmats

    $20.00
    Add to cart