Showing 21–40 of 145 results

  • Custom knit-in logo jaquard dress socks. 

    Choice of two colors – maroon or blue

     

    Disco Biscuits knit dress socks – color options

    $15.00

    Custom knit-in logo jaquard dress socks. 

    Choice of two colors – maroon or blue

     

  • Above the Waves design by Zack Katz

    Screenprinted on ladies flowy high-neck black tank tops.

    Above the Waves logo high neck ladies tank

    $30.00

    Above the Waves design by Zack Katz

    Screenprinted on ladies flowy high-neck black tank tops.

  • This is a preorder expected to ship the week of 12/3

    This high-quality, lightweight zip-up water-resistant windbreaker features embroidered logo front left chest.

    Your choice of two colors, black/gray or black/camo.

    Jacket specs:

    • 82 Gm 100% polyester fabric with interior water resistant coating
    • matte finish eyelets and zippers
    • three panel hood with fine mesh liner
    • scuba neck with self neck tape
    • welt pockets with mesh pocket bags
    • tightening toggle at waistband
    • elastic cuffs
    • locker loop in center back

    Lightweight Zip Windbreaker – color options

    $65.00

    This is a preorder expected to ship the week of 12/3

    This high-quality, lightweight zip-up water-resistant windbreaker features embroidered logo front left chest.

    Your choice of two colors, black/gray or black/camo.

    Jacket specs:

    • 82 Gm 100% polyester fabric with interior water resistant coating
    • matte finish eyelets and zippers
    • three panel hood with fine mesh liner
    • scuba neck with self neck tape
    • welt pockets with mesh pocket bags
    • tightening toggle at waistband
    • elastic cuffs
    • locker loop in center back
  • Silicone cell phone wallet hold cards and cash, and bends to serve as a phone stand.

    Black with white imprint.

    Cell Phone Credit Card Sleeve with stand

    $10.00

    Silicone cell phone wallet hold cards and cash, and bends to serve as a phone stand.

    Black with white imprint.

  • Welcome to your new favorite hoodie, ladies.  This long length hoodie dress is screenprinted across the chest with the band name and embroidered on the pocket with the round Disco Biscuits logo.

    Created for comfort using an exclusive Special Blend fabric and a stylish silhouette, this hoodie provides the ultimate in cozy coverage. Features include a crossover neck, thumbholes, and 2 drawcords in contrasting colors.

    Size chart in additional photos.

    Ladies Hoodie Dress

    $65.00

    Welcome to your new favorite hoodie, ladies.  This long length hoodie dress is screenprinted across the chest with the band name and embroidered on the pocket with the round Disco Biscuits logo.

    Created for comfort using an exclusive Special Blend fabric and a stylish silhouette, this hoodie provides the ultimate in cozy coverage. Features include a crossover neck, thumbholes, and 2 drawcords in contrasting colors.

    Size chart in additional photos.

  • Embroidered gold Disco Biscuits crest on the front left chest. Choice of black or purple robe.

    Made of 100% microfiber polyester fleece fabric, this is THE most luxurious fleece robe available.

    • One Size
    • 48” long
    • 2 patch pockets
    • 100% microfiber polyester

    tDB Embroidered Robe – color options

    $85.00

    Embroidered gold Disco Biscuits crest on the front left chest. Choice of black or purple robe.

    Made of 100% microfiber polyester fleece fabric, this is THE most luxurious fleece robe available.

    • One Size
    • 48” long
    • 2 patch pockets
    • 100% microfiber polyester
  • High-quality, sublimated full-color all-over print ladies leggings.

    Full length leggings with comfortable waistband.

    tDB New Ladies Leggings

    $65.00

    High-quality, sublimated full-color all-over print ladies leggings.

    Full length leggings with comfortable waistband.

  • Heavyweight black zip up hoodie.

    Glow in the dark back print art

    Design by Christian Jaxheimer.

    Firefly Heavyweight Hoodie

    $65.00

    Heavyweight black zip up hoodie.

    Glow in the dark back print art

    Design by Christian Jaxheimer.

  • Pullover hoodies printed on super soft special blend navy blue hoodies, with colorful blue and pink logo screenprinted on the front, geometric medallion panther on the back, and THE DISCO BISCUITS down the right sleeve.

    Design by Christian Jaxheimer.

    See size chart in additional photos.

    Garment specs:

    • 8.5 oz (280 gm) 80% cotton/20% polyester blend fleece
    • jersey lined hood and dyed-to-match drawcords
    • 1×1 ribbing at cuffs & waistband
    • metal eyelets
    • standard fit

    Panther Pullover Hoodie

    $65.00

    Pullover hoodies printed on super soft special blend navy blue hoodies, with colorful blue and pink logo screenprinted on the front, geometric medallion panther on the back, and THE DISCO BISCUITS down the right sleeve.

    Design by Christian Jaxheimer.

    See size chart in additional photos.

    Garment specs:

    • 8.5 oz (280 gm) 80% cotton/20% polyester blend fleece
    • jersey lined hood and dyed-to-match drawcords
    • 1×1 ribbing at cuffs & waistband
    • metal eyelets
    • standard fit
  • This 6″ Snowboard Stomp pad protect assists riders when getting off of chair lifts. Mounted between the bindings, stomp pads are used to secure the rear foot when getting off of a chair lift at the top of the mountain. All pads come with high performance adhesive for secure mounting to the board by the recipient. Logo is protected under the clear material of the pad, which provides traction for keeping the rear foot in position.

    INSTALLATION INSTRUCTIONS:

    You want to install your stomp pad as close to your back binding as you can – this will make it feel as close to your normal stance as you can make it. And it will also mean that you can lean your boot against the binding for extra stability.

    Make sure that you position the stomp pad on the inside of the back binding.

    Here’s how to find the best spot for your stomp pad.

    1. Place your snowboard on the ground and put your boots on
    2. Place your back foot on the snowboard on the inside of the back binding, close to the back binding so that you are still standing upright and so that the side of your boot is touching the side of the binding
    3. Mark the points on the board where the inside and outside of your boots touch the board
    4. When you place your stomp pad it should be inside these tape marks (or at least not outside the tape mark that’s next to the binding)

    Installing the stomp pad

    Now you have the position of your stomp pad it’s time to install it/them

    1. Thoroughly clean and dry the area of your board where you will be placing the stomp pad/s. If you try to attach them to a dusty, unclean or wet surface they may lose their stick quickly
    2. To ensure the best possible stick make sure that you are in a warm room or heat up the boards surface with a hair dryer
    3. Remove the backing to expose the adhesive and place on your stomp pad.
    4. Then remove the other side of adhesive and place the stomp pad in the position you marked earlier. Press down as hard as possible and hold the pad in place for a while.
    5. Let the adhesive dry for 24 hours.

    tDB Snowboard Stomp pad

    $20.00

    This 6″ Snowboard Stomp pad protect assists riders when getting off of chair lifts. Mounted between the bindings, stomp pads are used to secure the rear foot when getting off of a chair lift at the top of the mountain. All pads come with high performance adhesive for secure mounting to the board by the recipient. Logo is protected under the clear material of the pad, which provides traction for keeping the rear foot in position.

    INSTALLATION INSTRUCTIONS:

    You want to install your stomp pad as close to your back binding as you can – this will make it feel as close to your normal stance as you can make it. And it will also mean that you can lean your boot against the binding for extra stability.

    Make sure that you position the stomp pad on the inside of the back binding.

    Here’s how to find the best spot for your stomp pad.

    1. Place your snowboard on the ground and put your boots on
    2. Place your back foot on the snowboard on the inside of the back binding, close to the back binding so that you are still standing upright and so that the side of your boot is touching the side of the binding
    3. Mark the points on the board where the inside and outside of your boots touch the board
    4. When you place your stomp pad it should be inside these tape marks (or at least not outside the tape mark that’s next to the binding)

    Installing the stomp pad

    Now you have the position of your stomp pad it’s time to install it/them

    1. Thoroughly clean and dry the area of your board where you will be placing the stomp pad/s. If you try to attach them to a dusty, unclean or wet surface they may lose their stick quickly
    2. To ensure the best possible stick make sure that you are in a warm room or heat up the boards surface with a hair dryer
    3. Remove the backing to expose the adhesive and place on your stomp pad.
    4. Then remove the other side of adhesive and place the stomp pad in the position you marked earlier. Press down as hard as possible and hold the pad in place for a while.
    5. Let the adhesive dry for 24 hours.
  • 1/4″ thick acrylic magnet with full color design

    Design by Christian Jaxheimer

    Disco Biscuits Acrylic Magnet

    $8.00

    1/4″ thick acrylic magnet with full color design

    Design by Christian Jaxheimer

  • Worcester Palladium 10/19-10/20/2018 Poster

    $35.00
  • Knit winter hat with cuffed brim and pom. Knit-in logo design.

     

    This item will begin shipping 11/29

    tDB Knit pom ski hat

    $25.00

    Knit winter hat with cuffed brim and pom. Knit-in logo design.

     

    This item will begin shipping 11/29

  • Sublimated fabric mini tapestry with grommets in corners. Measures 30″ x 30″.

    Art by Christian Jaxheimer – First Earth

    tDB Mini Tapestry

    $55.00

    Sublimated fabric mini tapestry with grommets in corners. Measures 30″ x 30″.

    Art by Christian Jaxheimer – First Earth

  • New Disco Biscuit Speaker Pin

    $15.00
  • Above the Waves logo design by Zack Katz

    Screenprinted across the front of navy/baby blue ladies fit baby rib raglan baseball tees with 3/4 length sleeves

    Garment is 100% cotton. Size chart in inches:

    S M L XL 2XL
    BODY LENGTH 23.75 24.75 25.75 26.75 27.75
    BODY WIDTH 14 15 16 17 18
    FULL BODY LENGTH 23.75 24.75 25.75 26.75 27.75
    SLEEVE LENGTH 18 18.5 19 19.5 20

    Above the Waves logo ladies baseball tee

    $35.00

    Above the Waves logo design by Zack Katz

    Screenprinted across the front of navy/baby blue ladies fit baby rib raglan baseball tees with 3/4 length sleeves

    Garment is 100% cotton. Size chart in inches:

    S M L XL 2XL
    BODY LENGTH 23.75 24.75 25.75 26.75 27.75
    BODY WIDTH 14 15 16 17 18
    FULL BODY LENGTH 23.75 24.75 25.75 26.75 27.75
    SLEEVE LENGTH 18 18.5 19 19.5 20
  • Colorful hot air balloon design logo screenprinted in full with additional print on the back featuring band name.

    Design by Dima Yastronaut.

    100% cotton shirt is hand dyes in shades of blue, purple, green and yellow

    Hot Air Balloon Tie Dye

    $35.00

    Colorful hot air balloon design logo screenprinted in full with additional print on the back featuring band name.

    Design by Dima Yastronaut.

    100% cotton shirt is hand dyes in shades of blue, purple, green and yellow

  • Asheville NC Salvage Station Poster

    $35.00
  • Robot design by Mark Serlo, screenprinted in full color on the front of steel gray unisex t-shirts. See size chart in additional photos.

    Disco Biscuits Robot Tee

    $30.00

    Robot design by Mark Serlo, screenprinted in full color on the front of steel gray unisex t-shirts. See size chart in additional photos.

  • Navy blue long sleeve thermal tee with contrast stitching and embroidered logo front left chest.

    Size chart, in inches, with garment laid flat:

    S M L XL 2XL
    SLEEVE LENGTH 27.38 28 28.75 29.5 30
    BODY WIDTH 18.75 20.25 22.25 24.25 26.25
    FULL BODY LENGTH 28.75 29.75 30.75 31.75 32.75

    Embroidered Logo Thermal Shirt

    $40.00

    Navy blue long sleeve thermal tee with contrast stitching and embroidered logo front left chest.

    Size chart, in inches, with garment laid flat:

    S M L XL 2XL
    SLEEVE LENGTH 27.38 28 28.75 29.5 30
    BODY WIDTH 18.75 20.25 22.25 24.25 26.25
    FULL BODY LENGTH 28.75 29.75 30.75 31.75 32.75